Thank you for your keen interest in Pak Elektron Limited and PEL Products. To get to the appropriate contact, please select one of the following links and download the PEL Manuals:

• User should carefully read the manual of the refrigerator prior to use.

• The refrigerator should be kept away from heat sources like heaters, cookers, stoves, direct sunlight etc.

• The refrigerator should be placed in a well- ventilated area. Small corners, stairs, cupboards or narrow spaces should be avoided.

• Refrigerator must be connected to a reliable earth point through a Three-pin arrangement.

• Wrap up food in proper sheeting such as plastic or Aluminum foil.

• Food should be arranged in the refrigerator as guided in the manual. Excessive loading of the Grid shelves should be avoided.

• The refrigerator should be defrosted periodically, before a maximum of 5 mm thick frost appears on the Freezer.

• Warm food should not be placed in the refrigerator. It should be left in the atmosphere for some time to cool down to room temperature, before putting in the refrigerator.

• Avoid placing too much food in the refrigerator, which would prevent free circulation of air in the refrigerator.

• After 2 or 3 months, clean the defrost water trays mounted on top of the compressor and front kick plate.

• Do not connect your appliance directly to the electrical supply mains, a circuit breaker of appropriate rating must be connected between the appliance and the mains.

• A reliable Voltage Stabilizer must be used in areas where the voltages are low beyond 190 Volts.

• Thermostat should never be permanently set in high values. Optimum Cooling results are achieved in the range from 2 to 5, depending on the ambient temperatures.

• Voltage fluctuations and frequent power shutdowns are harmful for the deep freezer. At least five minutes should be given before restarting the unit. Time Delay switches/arrangements are recommended for use in areas where these problems are frequent.

Download Air Conditioner Leaflet		167 Kb Download

• User should carefully read the manual of the air conditioner prior to use.

• The air conditioner should not be installed in areas that are exposed to direct sunlight as the sun heat reduces the efficiency of the machine.

• Air Filter should be cleaned regularly and should be free from dust, lint or other particles. A choked air filter may reduce the suction volume of air resulting in low cooling or ice formation on the evaporator fins.

• The AC should be serviced regularly. Most critical items during servicing are cleaning/washing of condenser and evaporator fins, fan motor and checking/tightening of all electrical connections.

• The AC should be connected with a firm electrical mains system. The size and quality of the power cables, circuit breaker, socket and plug should be appropriate.

• The AC should always be installed where isolation from the power mains is possible. During off condition, the units should be totally disconnected from the mains.

• Split AC's should be installed preferably by PEL authorized installers as per PEL recommendations/specifications so as to ensure proper operations.

• Room size calculations determine the correct Capacity of the air conditioner. These calculations should always be done prior to the size selection of the unit. As a thumb rule, one-ton load is good enough to provide sufficient cooling in a room with covered area of 150 square feet, with 10 feet high ceiling. Other room sizes can be handled accordingly.

• A reliable Voltage Stabilizer must be used in areas where the voltages are below 190 Volts.

• Thermostat should be set according to the temperature requirements of the room. This can minimize the power consumption of the unit.

• Voltage fluctuations and frequent power shutdowns are harmful for the air conditioner. Wait for at least five minutes before restarting the unit after every shutdown.